TobascoPID

Free for every dental office

The sensor, centered on the beam. Every time.

A snap-on collar for your x-ray cone. The sensor holder locks into its groove, so the sensor lands on the center of the beam with no ring to aim. Download a collar file made for your cone, free.

Get your free collar file
Concept animation · 50 seconds · no sound

Two steps

  1. 1

    Choose your x-ray unit

    Pick your brand and cone from the list and download the collar file. Not listed? Enter three measurements instead.

  2. 2

    Print it

    Print the file in the office, or send it to a 3D-print service. Instructions come with the file.

Start with step 1

Not listed? How to measure your cone

Use calipers, and measure in millimetres if you can. Take each diameter twice, turning the calipers a quarter turn, and enter the average.

  • Tip OD: outside diameter at the open end of the cone, the end that faces the patient.
  • Base OD: outside diameter where the cone meets the tubehead.
  • Cone length: from the tubehead to the tip, along the side of the cone.
  • Photo (optional): the cone from the side with a ruler beside it. Cone only, no patients. It helps us add your cone to the list.

Rectangular cones are not supported yet. Round cones only.

Tip OD Base OD Cone length
Replace with your measuring photos from GNYDM.

Step 1: choose your x-ray unit

Step 2: print your collar

Send it to a print service

  1. Upload TobascoPID_collar_half.step to a 3D-print service such as Xometry.
  2. Choose HP Multi Jet Fusion (MJF), Nylon PA 12, quantity 2.
  3. Add the note: “Clear all powder from the slits around the snap tongue.”

Print it in the office

Use the STL file. Nylon (MJF or SLS) works best for the snap tongues. Many dental resins are too brittle for them, so test the snap before relying on a resin print.

Line it, snap it on

Cut two strips of 1/16 in (1.6 mm) adhesive-backed silicone sheet to the size in your instructions, and stick one inside each half. Place the halves around the cone, front flush with the tip, and squeeze until both seams click. To remove, press both buttons and pull the halves apart.